“Called three places when the upstairs of our house would not cool. Moorhead was the only one who measured the load instead of just quoting a new system. Ended up being a zoning fix for a fraction of the price. Honest people.”
If your San Antonio home still has a Federal Pacific or Zinsco panel, your insurer probably already knows. We replace them, size the upgrade to your real load, and pull the permit.
Thanks for reaching out. We've got your request and we'll be in touch shortly, usually the same day. Need us right now? Call (830) 587-5790 — we're open 24/7.
Permitted + inspected
Federal Pacific and Zinsco panels — common in San Antonio homes built from the 1950s through the 1980s — have a documented failure-to-trip problem, and carriers increasingly refuse to cover them.
We replace the panel, size the new service to your actual load including AC and any EV charger, and handle the permit and inspection.
Call (830) 587-5790A panel upgrade is not glamorous, but it is the spine of a safe, modern home. Here is when San Antonio homes need one.
These panels can fail to trip under a fault — a real fire risk and a reason insurers balk. If you have one, replacing it is one of the highest-value safety upgrades in the house. We document it with a permit so it is on record for resale.
A lot of older San Antonio homes run a service that was fine for 1970 and is overwhelmed by central AC, a modern kitchen, and a charger. We size a 200-amp service to what your home actually draws now.
Being licensed for HVAC and electrical, we size the panel to carry the AC properly — the part panel-only electricians often get wrong. The breaker box and the condenser are the same job to us.
Every panel upgrade gets the local permit and inspection, wired to NEC 2023. It protects you, it is required, and it is the difference between a real upgrade and a liability hidden behind a cover.
Stone Oak, Alamo Ranch, Shavano Park, the sprawl past Loop 1604 — these subdivisions went up fast in the 1990s and 2000s on builder-grade 14-SEER equipment. Those units are now 15 to 20 years old and failing in batches. The classic call is the two-story where the upstairs never cools, because the original system was sized for square footage and ignored the stack of heat that builds on the second floor. We fix that with a real load calculation, a zoning damper, or a mini-split — not by selling you a bigger condenser and hoping.
| Service | Notes | Price |
|---|---|---|
| FPE / Zinsco panel evaluation | Safety report + replacement quote | $100–$150 |
| Whole-home surge protector | Type 2, panel-mounted, tested | $250–$450 |
| 200-amp panel upgrade | Written quote after load assessment | Quoted on site |
All prices flat-rate, all-in, written and approved before work starts. No travel surcharge for San Antonio.



From the historic homes inside Loop 410 to the new builds past 1604, we run calls across the San Antonio metro every week. A few of the areas we cover:
“Called three places when the upstairs of our house would not cool. Moorhead was the only one who measured the load instead of just quoting a new system. Ended up being a zoning fix for a fraction of the price. Honest people.”
“Our AC died during that August heat wave and Moorhead had a tech at our place in Stone Oak the same afternoon. Turned out to be a capacitor — he had the part on the truck, fixed it in under an hour, and charged exactly what he quoted. No upsell.”
“Called three places when the upstairs of our house would not cool. Moorhead was the only one who measured the load instead of just quoting a new system. Ended up being a zoning fix for a fraction of the price. Honest people.”
Tell us what the system's doing and we'll get right back to you — usually same day, anywhere in San Antonio. Prefer to talk? Call (830) 587-5790, day or night.
Thanks for reaching out. We've got your request and we'll be in touch shortly, usually the same day. Need us right now? Call (830) 587-5790 — we're open 24/7.
FPE/Zinsco replacement and 200-amp upgrades, permitted.