Heating & Furnace Repair
in Canyon Lake, TX

Heating Repair in Canyon Lake

Whether you run a gas furnace, a heat pump, or propane out on Comal County acreage, here is what we see when the heat quits.

Furnace Will Not Ignite

Usually a failed hot-surface ignitor or a dirty flame sensor — both common, both on the truck, both a same-visit fix. We test the whole ignition sequence rather than swapping parts blind.

Heat Pump Not Keeping Up

A lot of Canyon Lake homes run heat pumps, which work differently than a furnace. Low charge, a stuck reversing valve, or a failed defrost control all show up as "not enough heat." We diagnose the actual cause.

The Carbon Monoxide Check

On every heating visit we inspect the heat exchanger for cracks. A cracked exchanger can leak CO into the house, and it is the one furnace problem we will tell you to stop using the system over. Safety is not a flat-rate line item — it is the job.

Propane and Rural Setups

No natural gas out on the acreage means propane furnaces and heat pumps, which we service routinely. We come prepared for rural Comal County setups, not just city gas lines.

Why Canyon Lake Homes in Particular

Older cabins, bonus rooms over the garage, and screened porches somebody finally enclosed rarely have ductwork that reaches. A ductless mini-split gives those spaces real, zoned cooling without tearing into a house that was never built for central air.