Heating & Furnace Repair
in Austin, TX

Heating Repair in Austin

Whether you run a gas furnace, a heat pump, or propane out on Travis County acreage, here is what we see when the heat quits.

Furnace Will Not Ignite

Usually a failed hot-surface ignitor or a dirty flame sensor - both common, both on the truck, both a same-visit fix. We test the whole ignition sequence rather than swapping parts blind.

Heat Pump Not Keeping Up

A lot of Austin homes run heat pumps, which work differently than a furnace. Low charge, a stuck reversing valve, or a failed defrost control all show up as "not enough heat." We diagnose the actual cause.

The Carbon Monoxide Check

On every heating visit we inspect the heat exchanger for cracks. A cracked exchanger can leak CO into the house, and it is the one furnace problem we will tell you to stop using the system over. Safety is not a flat-rate line item - it is the job.

Propane and Rural Setups

No natural gas out on the acreage means propane furnaces and heat pumps, which we service routinely. We come prepared for rural Travis County setups, not just city gas lines.

Why Austin Homes in Particular

Most Austin HVAC outfits cannot touch your panel, and most electricians will not look at your condenser. We are licensed for both, so the crossover jobs - a charger that needs a panel upgrade, an AC tied to old wiring - get done in one coordinated visit.