A single-zone ductless mini-split runs about $5,570 to $9,580 installed in the New Braunfels and Seguin area. A multi-zone system that cools two to five rooms runs $8,570 to $15,525. What moves the number is how many indoor heads you need, the BTU size of each, how far the line-set has to run, and what the electrical side takes. Here is the honest breakdown, with real published prices, not a 'starting at' teaser.
A single-zone ductless mini-split runs about $5,570 to $9,580 installed in the New Braunfels and Seguin area. Go multi-zone for two to five rooms and it runs $8,570 to $15,525. The price is driven by how many indoor heads you need, the BTU size, the line-set run, and the electrical. Every Moorhead price is flat-rate and in writing before any work starts.
Single zone or multi-zone? That is the biggest number
Before anything else, the price splits on how many rooms you are cooling.
- Single zone - $5,570 to $9,580. One outdoor unit, one indoor head, one room. The hot bedroom, a garage or shop you finally want comfortable, a sunroom, an addition the ducts never reached, or the office over the garage that cooks all afternoon.
- Multi-zone (2 to 5 rooms) - $8,570 to $15,525. One outdoor unit feeding several indoor heads, each with its own thermostat. A few problem rooms, or a whole home with no ductwork at all.
A single outdoor unit can feed several heads, but it is not a bottomless well. Hang too many heads on too small a condenser and the system spends a Texas August out of breath. The head count has to match the compressor, which is the whole reason we size it instead of eyeballing it. If you are still deciding between ductless and a central system, start with mini-split vs central AC.
What actually moves the number
Number of zones
Every indoor head is its own piece of equipment and its own labor to mount, run, and commission. One head is the cheapest ductless you can buy; a five-head system that cools the whole house is the most. The jump from single to multi-zone is the single biggest lever on the price.
BTU sizing (the load calculation)
A mini-split is sized in BTUs to the heat a room actually gains, not to its square footage off a chart. Oversize it and it short-cycles, which in our humidity leaves you with a cold, clammy room it never properly dries out. Undersize it and it never catches up on a 100-degree afternoon. We run a Manual J load calculation so each head is the size the room needs.
The line-set run
The line-set is the pair of refrigerant lines running from the outdoor unit to each indoor head. A head on the far side of the house, up a second story, or through an awkward wall takes more line, more labor, and sometimes a cover to keep it tidy. A short, clean run is cheaper than a long, fussy one.
The electrical
A mini-split needs its own dedicated circuit and a disconnect, and an older panel sometimes needs a spot made for it. This is where a lot of homeowners get a second bill from an electrician. We are a licensed electrical contractor as well as an HVAC company, so that work is the same crew on the same visit, in the same flat quote.
The prices, published
We are one of the few shops around here that posts real numbers. These are installed, all-in - equipment, labor, permit, and haul-away - and your exact price is quoted flat, in writing, before we start.
| What you are putting in | Installed, all-in |
|---|---|
| Single-zone mini-split (one room) | $5,570 - $9,580 |
| Multi-zone mini-split (2 to 5 rooms) | $8,570 - $15,525 |
| For comparison: central AC-only replacement | $8,570 - $12,320 |
Ranges from current Moorhead flat-rate pricing for the New Braunfels and Seguin area; your exact number comes from a free in-home load calculation, in writing before any work begins.
Is a mini-split the right spend?
A mini-split is the right money when the problem is a room, not the whole house:
- A stubborn hot room the central system never evens out.
- A garage, shop, or she-shed with no duct reaching it.
- An addition or converted space the original system was never sized for.
- An upstairs that loses the fight every afternoon.
- A whole home with no ductwork at all, where going ductless beats tearing in ducts.
When the whole house is the problem and you already have decent ducts, a central system is usually more cooling per dollar than a stack of heads - a central AC-only replacement runs $8,570 to $12,320. One more thing worth knowing: a mini-split is a heat pump, so it heats that zone too, and in a mild Texas winter it does the job without a furnace. If heating is part of the decision, read heat pump vs gas furnace.
What lowers the cost
- Financing. We offer financing with 0% APR for 18 months on select systems, and plans from about $99 a month. For most people the monthly matters more than the sticker.
- The right number of zones. A head in a room nobody really uses is money sitting idle on the wall. We will tell you where a zone earns its keep and where it does not.
- Not over-buying. The top-tier multi-zone with every feature is a fine machine, but most homes do not need it. We size to the rooms, not to the invoice.
One thing that will not lower it in 2026: the federal tax credit. Ductless heat pumps used to qualify for the 25C credit, but it ended for systems installed after 2025 - here is what changed.
The Moorhead version
We quote ductless flat-rate, all-in, and in writing before we touch anything - equipment, labor, permit, and haul-away in one number that does not change when the job gets harder. The sizing comes from a real load calculation, not a square-footage guess, and because we are a licensed electrician as well as an HVAC contractor, the dedicated circuit a mini-split needs is handled by the same crew on the same day. See how we handle ductless mini-splits in New Braunfels, or get your price online.
