A new gas furnace in Texas runs about $3,500 to $6,000 installed on its own, or $9,180 to $12,865 as part of a furnace-plus-AC system. What moves the number is the size, the efficiency (a basic 80% unit versus a high-efficiency 90%-plus), and whether your ductwork, gas line, or venting needs work. Here is the honest breakdown, with real published prices, not a 'starting at' teaser.
A new gas furnace by itself runs about $3,500 to $6,000 installed in the New Braunfels and Seguin area. As part of a full furnace-plus-AC system it runs $9,180 to $12,865. The spread comes down to size, efficiency, and the condition of your ducts, gas line, and venting. Every Moorhead price is flat-rate and in writing before any work starts.
First question: just the furnace, or the whole system?
The biggest thing that decides the price is whether you are replacing the furnace alone or the furnace and the air conditioner together.
- Furnace only - $3,500 to $6,000. You keep your existing AC and coil and swap just the gas furnace. The right call when the AC side is healthy and only the heat is failing.
- Furnace + AC together - $9,180 to $12,865. When both are old, replacing them as a matched system is usually the better money than doing them a year apart - one trip, one permit, and the two pieces are sized to work together.
- Packaged gas unit - $9,620 to $16,590. The all-in-one rooftop or ground units some Texas homes use, where the furnace and AC share one cabinet.
Price your system in 30 seconds →
What actually moves the number
Size (the load calculation)
A furnace is sized in BTUs to the heat your house actually loses, not to its square footage off a chart. Too small and it runs forever on the coldest night; too big and it short-cycles and wears out early. We do a Manual J load calculation so you pay for the size you need, not the size that is easiest to guess.
Efficiency: 80% vs 90%-plus
A standard furnace is about 80% efficient (AFUE) - for every dollar of gas, 80 cents becomes heat. A high-efficiency condensing furnace is 90% to 97%. The high-efficiency unit costs more up front and needs different venting (PVC, not metal), but it burns less gas every winter. In our mild Texas winters the payback is slower than up north, so 80% is often the honest pick - we will run both numbers and let you choose.
Single-stage, two-stage, or modulating
A single-stage furnace is full-blast or off. Two-stage and modulating units run at lower output most of the time, which means steadier temperatures, quieter operation, and better comfort - for more money. Worth it for some homes, not all.
The stuff behind the walls
If your ductwork leaks, your gas line is undersized, or a high-efficiency unit needs new venting run, that adds to the job. We find it on the free visit and put it in the quote up front, not as a surprise on the invoice.
The prices, published
We are one of the few shops around here that posts real numbers. These are installed, all-in - equipment, labor, permit, and haul-away - and your exact price is quoted flat, in writing, before we start.
| What you are replacing | Installed, all-in |
|---|---|
| Gas furnace only (keep your AC) | $3,500 - $6,000 |
| Furnace + AC, 80% system | $9,180 - $12,865 |
| Packaged gas unit (all-in-one) | $9,620 - $16,590 |
| Furnace tune-up (not a replacement) | $99 flat |
Ranges from current Moorhead flat-rate pricing for the New Braunfels and Seguin area; your exact number comes from a free in-home load calculation, in writing before any work begins.
When a repair is the smarter money
A new furnace is a big number, and sometimes it is the wrong one. A bad ignitor or flame sensor is a few hundred dollars, not a few thousand. The honest rule: if the furnace is under about 12 to 15 years old and the repair is a fraction of a replacement, fix it. If it is older, the repair is big, or you are facing repeated failures, replacement starts to make sense. Run it through the repair-or-replace guide before anyone talks you into a new system.
What lowers the cost
- Financing. We offer financing with 0% APR for 18 months on select systems, and plans from about $99 a month. For most people the monthly matters more than the sticker.
- Rebates, when they are real. Utility and state programs come and go and depend on your provider and income. We tell you which ones you actually qualify for, in writing.
- Not over-buying. A high-efficiency modulating furnace is a great machine, but in a mild Texas winter a right-sized 80% unit often makes more sense. We will not sell you more furnace than your climate pays back.
One thing that will not lower it in 2026: the federal furnace tax credit. The 25C credit ended for systems installed after 2025 - here is what changed.
The Moorhead version
We quote furnaces flat-rate, all-in, and in writing before we touch anything - equipment, labor, permit, and haul-away in one number that does not change when the job gets harder. The sizing comes from a real load calculation, not a square-footage guess, and because we are a licensed electrician as well as an HVAC contractor, anything the install needs on the electrical side is handled by the same crew. See how we handle furnace install and repair in New Braunfels, or get your price online.
